User Manual

You can compile and flash your sketch to the WICED Feather using the 'Download' arrow icon at the top of the IDE:

You should see the USB DFU progress as the update advances, and there will be a 'Done Uploading' message in the

top left of the status bar when you are done:

Testing the Sketch

Unlike many of the example sketches, this example will not wait for the USB CDC Serial Port to open before executing

the code.

If you have an OLED display properly connected, data should appear on it as soon as the USB DFU flash update

process is completed:

The data rendered on the display will depend on the way that you configure the example sketch, but the top

and bottom lines are reserved for WiFi and LIPO information, and the two middle lines (referred to as the

'Message Area' in Adafruit_FeatherOLED) can be used to render any text or messages.