User Manual

IDE:

You should see the USB DFU progress as the update advances, and there will be a 'Done Uploading' message in the

top left of the status bar when you are done:

Testing the Sketch

Wait a few seconds for the USB CDC serial interface to enumerate, and then open the Serial Monitor using either the

Serial Monitor icon in the upper-right of the IDE or via Tools > Serial Monitor:

This will cause the WICED Feather to attempt to connect to the access point, and then it will attempt to connect to the

netcat TCP Server:

At this point go to the top of the serial monitor and enter any character into the text box at the top and click the SEND