User Manual

Updating Firmware

As new versions of the WiFi101 library come out, you may end up getting a complaint that the library and WINC1500

firmware are out of sync:

No problem - you can update the firmware through your Arduino/compatible! Start by loading up the FirmwareUpdater

sketch

If you're running 19.5.2 there is no need to update to 19.5.4, despite what the WiFi101 library says it should

work just fine and you could brick your device by updating, it is not perfectly foolproof! Thanks :)



If you are using a Feather M0 or WINC1500 breakout, don't forget to update the pins as necessary with

