Datasheet

Install Gamepad PCB

Next up, let's fasten #4-40 3/8 sized machine screws

into the mounting holes on the corners of the gamepad

PCB. Insert them from the top of the PCB so that they're

just barely protruding from the back side. This makes it

easier to mount it to the standoffs in the case.

Now, insert the rubber D-Pad, Action Buttons and

Pause/Start actuators into the cutouts of the top case

part. Place the gamepad PCB over the standoffs and line

them up with screws. Slowly (and carefully) fasten the

screws into the standoffs. However, DO NOT fasten

them all the way through! Only fasten them down until

they're deep enough to be lower than the height of the

case. Please reference the photo - if screws are inserted

too far, they could protrude through the surface of the

case.

DO NOT insert screws all the way through standoffs! Reference the photo to see required depth.