Datasheet

Take note of the two circles highlighting the pins. The left pin (blue) will connect to the negative pin on the amp, while

the right pin (red) connects to the positive pin. The middle pin does not need to be tinned (disregard the tinning in the

photo).

Place the tip of the soldering iron over the pin and apply a small amount of solder. This will make connecting wires to

the audio amp much easier.

Connect Wires to Raspberry Pi

Solder the new wires to the pins on the bottom of the Raspberry Pi. The negative(blue) wire connects to the left pin,

while the positive(ed) wire connects to the right pin.