Datasheet

Connect Amp to PowerBoost 1000C

Slip on a piece of heat shrink tubing to the wires

connected to the Vin and Gnd pins. Next, secure the

PowerBoost 1000C to the helping third hands. Solder

the VIN wire from the amp to the 5V pin on the

PowerBoost. Then, solder the Gnd wire from the amp to

the G pin on the PowerBoost 1000C.

Connected Amp, Speaker and PowerBoost 1000C

Now our amplifier and speaker are wired up the PowerBoost 1000C.

Test fit Power Switch

Next up we need to connect our slide switch to the

PowerBoost 1000C. First, we should do a test fit and see

if our switch can fit into the case. Insert the switch into

the switch cutout of the bottom case. Press it all the way

through. If it's too tight, you can use a filing tool to open

it up.