Datasheet

Peel Cable from Connector

With the top removed from the connector, carefully peel

the ribbon cable from the connector. You should be left

with the top part and the female connector. You can

discard the ribbon cable.

Install Connector to Shortened Ribbon

Cable

Grab the longer piece of the ribbon cable from earlier

and lay the cut end over the top piece - The ribbon

cable should nicely fit into the grooves of the top piece.

Now grab the female connector and insert the top piece

into back onto the connector. Make sure the

arrow/triangle marking lines up with the side of the

ribbon cable with the single white colored wire. Press

the two pieces together and make sure the clips nicely

fit into the sides of the connector.

Slowly peel the ribbon cable off - If any metal bits come out, carefully push them back into the connector.