Datasheet

Cut Cable

With the cable split in two, set aside the longer end and keep the short end handy - we need to remove the connector

from the end of it.

Removing Connector

Take a close look at the bottom of the connector. You'll

see two tiny holes near each side. Now take a look at

the side. You'll see the connector has a clip that is held

in place with a notch. The goal here is to push that clip

away from the notch so we can fit the top from the

connector. You can fit something small and pointy such

as a needle into the holes and push the clip away from

the notch while pulling the top from the connector.

When the clip is free, carefully pull the top part out.

You'll need to do this for both sides.