Datasheet

Be careful tapping the standoffs from the top -To

prevent puncturing the surface, DO NOT tap all the way

through the standoff. Be careful not to tap too fast or

forcefully to avoid damaging the standoffs.

Test Fit Openings

Use a hobby knife to remove any excess bits from printing. Lay the components over the standoffs to see if mounting

holes line up. See if the port cutouts are in the right place. If they don't, use a filing tool to open them up.

Finishing Parts

You can smooth the parts by applying epoxy resin like Smooth-On's XTC-3D. To finish the surface, wait for it to dry and

sand it down. Apply a filler primer paint and a colored top coat of spray paint to make it extra smooth.