Datasheet

for (i=0; i<errno; i++) {

digitalWrite(13, HIGH);

delay(100);

digitalWrite(13, LOW);

delay(100);

}

for (i=errno; i<10; i++) {

delay(200);

}

// This line is not needed if you have Adafruit SAMD board package 1.6.2+

// #define Serial SerialUSB

void setup() {

// connect at 115200 so we can read the GPS fast enough and echo without dropping

chars

// also spit it out

Serial.begin(115200);

Serial.println("\r\nAnalog logger test");

pinMode(13, OUTPUT);

// see if the card is present and can be initialized:

if (!SD.begin(cardSelect)) {

Serial.println("Card init. failed!");

error(2);

}

char filename[15];

strcpy(filename, "ANALOG00.TXT");

for (uint8_t i = 0; i < 100; i++) {

filename[6] = '0' + i/10;

filename[7] = '0' + i%10;

// create if does not exist, do not open existing, write, sync after write

if (! SD.exists(filename)) {

break;

}

logfile = SD.open(filename, FILE_WRITE);

if( ! logfile ) {

Serial.print("Couldnt create ");

Serial.println(filename);

error(3);

}

Serial.print("Writing to ");

Serial.println(filename);

pinMode(13, OUTPUT);