Datasheet

AT+BLEURIBEACON=http://www.adafruit.com/blog
OK
# Reset to change the advertising data
ATZ
OK
If the supplied URI is too long you will get the following output:
AT+BLEURIBEACON=http://www.adafruit.com/this/uri/is/too/long
URL is too long
ERROR
If the URI that you are trying to encode is too long, try using a shortening service like bit.ly, and encode the shortened URI.
UriBeacon should be considered deprecated as a standard, and EddyStone should be used for any future development. No further development
will happen in the Bluefruit LE firmware around UriBeacon.
Deprecated: AT+EDDYSTONEENABLE
This command will enable Eddystone (http://adafru.it/fSA) support on the Bluefruit LE module. Eddystone support must be enabled before the
other related commands can be used.
Codebase Revision: 0.6.6
Parameters: 1 or 0 (1 = enable, 0 = disable)
Output: The current state of Eddystone support if no parameters are provided (1 = enabled, 0 = disabled)
This command was removed in firmware 0.7.0 to avoid confusion. Use AT+EDDYSTONESERVICEEN in 0.7.0 and higher.
# Enable Eddystone support
AT+EDDYSTONEENABLE=1
OK
# Check the current Eddystone status on the module
AT+EDDYSTONEENABLE
1
OK
AT+EDDYSTONEURL
This command will set the URL for the Eddystone-URL (http://adafru.it/fSB) protocol.
Codebase Revision: 0.6.6
Parameters:
The URL to encode (mandatory)
An optional second parameter indicates whether to continue advertising the Eddystone URL even when the peripheral is connected to a
central device
Firmware 0.6.7 added an optional third parameter for the RSSI at 0 meters value. This should be measured by the end user by checking the
RSSI value on the receiving device at 1m and then adding 41 to that value (to compensate for the signal strength loss over 1m), so an RSSI
of -62 at 1m would mean that you should enter -21 as the RSSI at 0m. Default value is -18dBm.
Output: Firmware <= 0.6.6: none. With firmware >= 0.6.7 running this command with no parameters will return the current URL.
# Set the Eddystone URL to adafruit
AT+EDDYSTONEURL=http://www.adafruit.com
OK
# Set the Eddystone URL to adafruit and advertise it even when connected
AT+EDDYSTONEURL=http://www.adafruit.com,1
OK
AT+EDDYSTONECONFIGEN
This command causes the Bluefruit LE module to enable the Eddystone URL config service for the specified number of seconds.
This command should be used in combination with the Physical Web application from Google, available for Android (http://adafru.it/edi) or
iOS (http://adafru.it/edj). Run this command then select the 'Edit URL' option from the app to change the destination URL over the air.
Codebase Revision: 0.6.6
© Adafruit Industries
https://learn.adafruit.com/introducing-the-adafruit-bluefruit-le-uart-
friend
Page 72 of 115