Datasheet

This tutorial does not need to use the MODE pin, make sure you have the mode switch in CMD mode if you do not configure & connect a
MODE pin
Don't forget to also connect the CTS pin on the Bluefruit to ground if you are not using it! (The Flora has this already done)
Running the Sketch
Once you upload the sketch to your board (via the arrow-shaped upload icon), and the upload process has finished, open up the Serial Monitor
via Tools > Serial Monitor, and make sure that the baud rate in the lower right-hand corner is set to 115200:
At this point you can open the Physical Web Application for Android (http://adafru.it/edi) or for iOS (http://adafru.it/edj), and you should see a link
advertising Adafruit's website:
© Adafruit Industries
https://learn.adafruit.com/introducing-the-adafruit-bluefruit-le-uart-
friend
Page 55 of 115