Datasheet

UriBeacon

The UriBeacon example shows you how to use the built-in UriBeacon AT commands to configure the Bluefruit LE module as a UriBeacon

advertiser, following Google's Physical Web UriBeacon (http://adafru.it/edk) specification.

Opening the Sketch

To open the ATCommand sketch, click on the File > Examples > Adafruit_BluefruitLE_nRF51 folder in the Arduino IDE and select uribeacon:

This will open up a new instance of the example in the IDE, as shown below. You can edit the URL that the beacon will point to, from the default

http://www.adafruit.com or just upload as is to test

Configuration

Check the Configuration! page earlier to set up the sketch for Software/Hardware UART or Software/Hardware SPI. The default is hardware SPI

If using software or hardware Serial UART:

https://learn.adafruit.com/introducing-the-adafruit-bluefruit-le-uart-

friend

Page 54 of 115