Datasheet

MODE pin

Don't forget to also connect the CTS pin on the Bluefruit to ground if you are not using it! (The Flora has this already done)

Running the Sketch

Once you upload the sketch to your board (via the arrow-shaped upload icon), and the upload process has finished, open up the Serial Monitor

via Tools > Serial Monitor, and make sure that the baud rate in the lower right-hand corner is set to 115200:

To send an AT command to the Bluefruit LE module, enter the command in the textbox at the top of the Serial Monitor and click the Send button:

The response to the AT command will be displayed in the main part of the Serial Monitor. The response from 'ATI' is shown below:

https://learn.adafruit.com/introducing-the-adafruit-bluefruit-le-uart-

friend

Page 30 of 115