Datasheet

Two parallel, breadboard-friendly breakouts on either side give you access to:

1 x Analog input (1.0V max)

9 x GPIO (3.3V logic), which can also be used for I2C or SPI

2 x UART pins

2 x 3-6V power inputs, reset, enable, LDO-disable, 3.3V output

One breakout at the end has an "FTDI" pinout so you can plug in an FTDI or console cable to upload software and

read/write debugging information via the UART. When you're done with your coding, remove the cable, and this little

module can be embeded into your project box.