Datasheet

Finally, solder the two

mechanical tabs on the side to

keep the USB connector solidly

in place.

On/Off Switch

The PowerBoost 1000C does not come with an on/off switch for the output, but its very

easy to add one! Just grab a Breadboard friendly SPDT slide switch from the adafruit

shop. (http://adafru.it/drN)

We will be turning the boost on/off via the ENABLE pin, so the switch does not have to

carry any power, it is only signalling to the boost converter what to do. This means the

switch can be small. Use any switch you like, if it is 0.1" spacing thats ideal. If your switch

only has two pins instead of three, tie one pin to GND and the other pin to EN - when the

switch is closed, the power will turn off

https://learn.adafruit.com/adafruit-powerboost-1000c-load-share-usb-

charge-boost

Page 14 of 23