Datasheet

This design uses the hardware SPI pins (SCK, MOSI, MISO, CE0, CE1) as well as GPIO #25 and #24. All other GPIO are

unused. Since we had a tiny bit of space, there's 5 spots for optional slim tactile switches wired to five GPIOs, that you

can use if you want to make a basic user interface. For example, you can use one as a power on/off button.

We have a right-angle 26-pin connector off to the side. You can connect a classic 26-pin Raspberry Pi GPIO cable in

order to access the rest of the GPIO through a Cobbler, etc.

To make it super easy for use: we've created a custom kernel package based of off Notro's awesome framebuffer

work, so you can install it over your existing Raspbian (or derivative) images in just a few commands.