Datasheet

Now unplug and plug in again the FT232H board and check device manager again to find the USB Serial Port (COMx) node in

the Ports (COM & LPT) node. That's it, you're all set to access the device as a serial COM port in Windows!

Serial Usage

Once any necessary serial port drivers are installed, you're ready to use the FT232H as a USB to serial UART. Let's perform a

simple loopback test to confirm you can read and write data with the UART. This test will connect the TX pin to the RX pin so any

data sent to serial UART will be immediately received and echoed back to you.

Using a jumper wire, connect pin D0 (TX) to D1 (RX) on the FT232H breakout as shown below.

Now open a serial console for the FT232H board and check that anything you type is echoed back to you.

Windows