Datasheet

Click the up/down arrows on the driver select box to the right of the green arrow and select the libusbK driver as shown above.

Now click the Replace Driver button to replace the FTDI driver with the libusb-based driver. After the driver replacement finishes

you can close Zadig tool.

To check that the driver was successfully replaced, open Device Manager from Control Panel or searching in the Start menu. You

should see a new top level node libusbK USB Devices and the USB Serial Converter underneath it as shown below.

If you see the libusbK node and USB serial device, move on to the next step to install libftdi.

If you don't see the libusbK node, try unplugging and plugging back in the FT232H breakout. If you still don't see the node, run

Zadig tool again and follow the steps above again to make sure you replace the FTDI driver for the device with the libusbK driver.

libftdi Install

This step will install libftdi's Python library. Carefully follow the steps below to make sure the library is installed.

Start by downloading the binary version of the libftdi library by clicking the button below. This binary is provided by the picusb

USB resources project (http://adafru.it/srb).

libftdi1-1.0_devkit_mingw32_17Feb2013.zip

http://adafru.it/src