Datasheet

Timer (Toggle Only)

By default, the toggle sensor is configured for

infinte time-out. it will stay on until you touch

the sensor to turn it off. It also supports a

configurable time-out to turn off the output

automatically after a delay. To select this

mode, cut the 'TIMER' jumper and connect a

resistor & capacitor to the TIME pin. For a circuit

diagram and resistor/capacitor calculations,

see page 13 of the

datasheet (http://adafru.it/cgW).

You can also just connect TIME to Vdd and the

chip will turn off approx 15 minutes after being

turned on. Connect TIME to OUT and the chip

will time-out approx one hour after being turned

on.

Connecting to your Circuit.

The outputs of these touch switches are 'active high'. Use them like a positive logic signal,

or a pushbutton that shorts to VCC.