Datasheet

LED Control
The led indicators can be disabled for ultra-low
power applications. To disable the LED, simply
cut the jumper between the pads where
indicated on the back of the breakout board.
With the jumper cut, the LED can be controlled
externally via the LED pin on the header.
Speed vs. Power (Momentary
Only)
The Momentary version can be configured for
"Fast" mode (default) or low-power mode. Fast
mode requires 0.5mA. Low Power mode
requires just 50uA. To switch between the two,
cut the jumper on one side of the "mode" pads
and bridge the other side with a drop of solder.
© Adafruit Industries https://learn.adafruit.com/adafruit-capacitive-touch-sensor-breakouts Page 13 of 32