Datasheet

You'll need to slide the terminal blocks
together. They come in 2 and 3-piece parts but
you can easily connect them to make any size.
Get ready by putting the PCB in a vise. Then
you can start by placing one of the 8-piece
terminal blocks in the "Analog" breakout area.
Check to make sure that the terminal blocks
are facing the right way! You want the 'mouth'
to face outward.
The terminal blocks should 'press fit' pretty
nicely so they stay in place. If they seem a little
loose, you can use tape to hold down the
terminal blocks while you solder them.
© Adafruit Industries https://learn.adafruit.com/adafruit-proto-screw-shield Page 14 of 24