Datasheet

You'll need to slide the terminal
blocks together. They come in 2
and 3-piece parts but you can
easily connect them to make any
size.
Get ready by putting the PCB in a
vise. Then you can start by
placing one of the 8-piece
terminal blocks in the "Analog"
breakout area.
Check to make sure that the
terminal blocks are facing the
right way! You want the 'mouth'
to face outward.
The terminal blocks should 'press
fit' pretty nicely so they stay in
place. If they seem a little loose,
you can use tape to hold down
the terminal blocks while you
solder them.
© Adafruit Industries https://learn.adafruit.com/adafruit-proto-screw-shield Page 14 of 24