Datasheet

.:download:.
breadboard layout sheet
http://ardx.org/BBLS01
.:view:.
assembly video
http://ardx.org/VIDE01
.:note:.
The 5v (red) wire is not used,
it's included for uniformity
with other circuits.
.:note:.
Make these by snapping the header
strip into 2 pin segments (with pliers)
Arduino
pin 13
LED
(light emitting diode)
resistor (560ohm)
(green-blue-brown)
gnd
(ground) (-)
08
CIRC-01
WHAT WE’RE DOING:
.:Getting Started:.
.:(Blinking LED):.
LEDs (light emitting diodes) are used in all sorts of clever things
which is why we have included them in this kit. We will start off
with something very simple, turning one on and off, repeatedly,
producing a pleasant blinking effect. To get started, grab the parts
listed below, pin the layout sheet to your breadboard and then plug
everything in. Once the circuit is assembled you'll need to upload the program. To do this plug the
Arduino board into your USB port. Then select the proper port in Tools > Serial Port > (the
comm port of your Arduino). Next upload the program by going to File > Upload (ctrl+U).
Finally, bask in the glory and possibility that controlling lights offers.
If you are having trouble uploading, a full troubleshooting guide can be found here: http://ardx.org/TRBL
Wire
10mm LED
x1
560 Ohm Resistor
Green-Blue-Brown
x1
2 Pin Header
x4
CIRC-01
Breadboard Sheet
x1
Parts:
The Internet
longer lead
+
THE CIRCUIT:
Schematic