Datasheet

project's wiring harness, or you can mount it with double-sided foam tape, or you could

design a bracket that it snaps into.

(The board dimensions are 0.8 x 1.25 inches.)

This is the NeoMatrix. It has two groups of three holes, labeled "DOUT / VDD / GND" on

one side, and "GND / VIN / DIN" on the other side.

GND: Ground. This completes the electrical circuit for power and for data. All of the

GND pins are the same on this board.

VDD: 5 volt power. This is where we power the LEDs. All of the VDD pins on this

board are the same.

DIN: Data input. This is the 5 volt data signal coming from the Fadecandy controller.

DOUT: Data output. We don't use this pin, since the NeoMatrix already has all 64

LEDs supported on a single Fadecandy controller channel.

To make the NeoMatrix go, we just need to wire it for data and for power. The thing we're

building is basically the same as the diagram you find in the Fadecandy README

document (http://adafru.it/cW0):