Datasheet

Plug the extra tall female header into the GPIO port on

the Pi as shown. Make sure its seated nice and flat

Place the PiTFT shield on top so all the pins stick

through the connector on the side. Gently flip the TFT

so its off to the side and wont be in your way while you

solder

Heat up your soldering iron, and grab some solder. Start

by tack-soldering one of the corners while pressing on

the plate to make it sit flat. Once you have one or two

pins done you can continue to solder each of the pins.

https://learn.adafruit.com/adafruit-pitft-28-inch-resistive-touchscreen-display-raspberry-

Page 10 of 70