Datasheet

Resistance is just as much a concern on tiny projects

too!

For wearable electronics we like conductive thread…it’s

flexible and withstands hand washing. Downside is that

it doesn’t carry much current. Here several strands of

conductive thread have been grouped to provide better

capacity for the + and – conductors down a pair of

suspenders.

(From the Pac Man Pixel

Suspenders (https://adafru.it/ciD) guide.)

Driving 5V NeoPixels from 3.3V Microcontrollers

Increasingly, microcontrollers are running at 3.3 Volts instead of 5 Volts. That’s great news for efficiency, but can

present a communication problem with 5V NeoPixels. The 3.3V signal from the microcontroller may not be “loud”

enough to register with the higher-voltage device. The manufacturer recommends a minimum signal voltage of 70% of

the NeoPixel voltage.

There are two ways this can be addressed:

1. Lower the voltage to the NeoPixels so it’s closer (or equal) to that of the microcontroller. This is why we

recommend LiPo batteries for FLORA projects: 3.7V is enough to run a short length of pixels, and the

microcontroller is comfortable at that voltage as well.

2. Use a logic level shifter to step up the signal from the microcontroller to the first pixel.