Datasheet

That's it! Thankfully you only have to do this once.

Windows 10 Driver Installation

If you're using Windows 10 the process to an install a custom driver is a little different than previous

Windows versions. When you plug in your device, like a Trinket/Gemma/Flora, you might not get a

pop up telling you to install a driver for the device. However you can follow the steps below to

manually install the driver.

These instructions show how to install the driver for a Trinket, but the steps should also apply to

Gemma and Flora (just expect to see a different name for the board).

First make sure you've downloaded the signed driver for the board from the sections above. Extract

the contents of the driver to a folder and remember where you put it.

Then plug in the Trinket/Gemma/Flora. You might hear a 'ding' from Windows that a new device

appeared but no dialog to install a driver. Don't worry keep following along to get the driver

installed.

Now open Device Manager by clicking the start button and typing Device Manager, then clicking

the device manager result to run it. You should see something like the following:

Industries

https://learn.adafruit.com/introducing-trinket Page 24 of 65