Datasheet

2) (http://adafru.it/1260) — designed
specifically for wearables and “soft circuits,”
these NeoPixels can be sewn using our
stainless conductive
thread (http://adafru.it/641) (traditional
soldering works too). Sold in packs of 4.
Breadboard-Friendly Smart
NeoPixel (http://adafru.it/1312) —
accommodates pin headers with standard
0.1" spacing. Sold in packs of 4 (headers are
sold separately).
NeoPixel Mini PCB (http://adafru.it/1612)
— the smallest NeoPixel breakout boards
have solder pads on the back. Sold in packs
of 5.
Diffused 8mm Through-Hole
NeoPixel (http://adafru.it/1734) — provides
NeoPixels in a more traditional LED form-
factor.
Flora RGB Smart NeoPixel (Version 2) —
Sheet of 20 (http://adafru.it/1559).
Breadboard-Friendly Smart NeoPixel —
Sheet of 25 (http://adafru.it/1558).
WS2812 RGB LED with Integrated Driver
Chip (http://adafru.it/1379) — bare
NeoPixels for advanced users wanting to
design their own custom boards and shapes.
10 pack. This is a surface-mount device, not
recommended for novice soldering. For
through-hole use, consider Breadboard-
Friendly NeoPixels (http://adafru.it/1312).
WS2811 LED Driver
Chip (http://adafru.it/1378) — contains the
NeoPixel controller circuit without the actual
LEDs (can be added separately). 10 pack.
Flora RGB Smart NeoPixel (Version 1) —
Discontinued, but listed here for
compatibility info. This earlier version of our
Flora NeoPixel is identified by a small driver
chip on the back side. V1 pixels were
originally programmed using the
Adafruit_FloraPixel library. All new code
should instead use the Adafruit_NeoPixel
© Adafruit Industries https://learn.adafruit.com/adafruit-neopixel-uberguide Page 10 of 39