Installation manual

Suite 7.1 Installation Manual
www.ada-usa.com 39
To Store the Customized Settings into Memory
1. Make sure that Pro Logic II Music or custom 1-3 mode is selected on the main display.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Change all the parameters that you wish as illustrated above.
5. Rotate the Mode knob until the cursor flashes over the P in PL.
6. Rotate the Input knob to select the memory recall that you want to store the custom Pro Logic II
parameters. You can select PLM, PL1, PL2, or PL3. Note: Your choices are limited when selecting
the parameters in the PLM recall menu.
7. Exit the Pro Logic Customization menu by selecting <P or M>.
To Recall the Customized Settings Stored into Memory
The Pro Logic II Custom modes are four of the numerous modes available on the Suite 7.1. You can
select these modes with the Mode knob on the front panel or store the custom modes as default or user
modes. The custom modes are also accessable with the PC program or an IR command.
To Store the Customized Settings into Memory
1. Make sure that Pro Logic II Music or custom 1-3 mode is selected on the main display.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Change all the parameters that you wish as illustrated above.
5. Rotate the Mode knob until the cursor flashes over the P in PL.
6. Rotate the Input knob to select the memory recall that you want to store the custom Pro Logic II
parameters. You can select PLM, PL1, PL2, or PL3. Note: Your choices are limited when selecting
the parameters in the PLM recall menu.
7. Exit the Pro Logic Customization menu by selecting <P or M>.
Pro Setup Menu Level Nine – Stereo Enhancements
Stereo Enhance is a proprietary ADA processing mode designed to improve playback of two-channel
source material with limited stereo separation. The two Stereo Enhancement parameters that can be
adjusted are Effect Delay and Effect Level. The Effect Delay parameter allows you to add up to 20 mS
of delay to the left channel with respect to the right channel. This delay is set prior to any Pro Logic
decoding. The Effect Level parameter sets the actual amount of the effect from –20 dB to + 20dB. We
recommend playing back a two-channel source while adjusting the Stereo Enhancement parameters.
To Set Stereo Enhancement Parameters
1. Select an Input label that is playing a two-channel signal and press the Input knob.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall
setup.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Rotate the Mode knob until the cursor flashes over the E in EH.
5. Press the Mode knob. The cursor will flash over the S in STEREO ENHANC LEVEL
6. Rotate the Mode knob until the cursor flashes over the S in STEREO ENHANC DELAY.
7. Rotate the Input knob to set the amount of left channel delay.
8. Rotate Input knob back until the cursor flashes over the S in STEREO ENHANC LEVEL.
9. Rotate the Input knob to set the amount of stereo enhancement.