Installation manual

Suite 7.1 Installation Manual
www.ada-usa.com 27
To Assign Video Sources to the Input
1. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
2. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
3. Press the Mode knob. The display will change to the Pro Setup menu and the cursor will flash over
the
L in LABELS/AV
4. Press the Mode knob again. The cursor will then flash over the I in INPUT 1.
5. Rotate the Mode knob until the cursor is flashing over the V in VIDEO.
6. Rotate the Input knob to select one of the 32 different video assignment combinations. Once you
have selected the input in this way, it remains in memory unless you change it again. There is no
need to press a knob.
Setting the Final or Maximum Input
Although there are ten available inputs, you may not use all of them. You can limit the amount of
inputs that you need to scroll through by setting the maximum input. For example, you could connect
four components to the Suite 7.1 and create two additional “virtual inputs” as described earlier. This
would be a total of six inputs used. You could then set the number of inputs to six. Now whenever you
scroll through the inputs, it will only go through 1 to 6, rather than 1 to 10.
To Set the Maximum Input
1. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
2. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
3. Press the Mode knob. The display will change to the Pro Setup menu and the cursor will flash over
the L in LABELS/AV
4. Press the Mode knob again. The cursor will then flash over the I in INPUT 1.
5. Rotate the Mode knob until the cursor is flashing over the M in MAX INPUT 10.
6. Rotate the Input knob to set the last of the ten inputs. Once you have selected the final input in
this way, it remains in memory unless you change it again. There is no need to press a knob.
Loading Files from the Cinema Reference Mach II PC Program
As mentioned earlier, the Cinema Reference Mach II PC Program allows you to setup and control the
Suite 7.1. When you use this program for set up you need to load all of the parameters into the Suite
7.1. This accomplished within the same setup menu used for labeling and assigning inputs. The setup
loading procedure is described in detail in the software instruction section of this manual.
To load a Setup File into the Suite 7.1
1. Make the changes within the software program as described in the Cinema Reference Mach II
PC Program
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall
setup.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Press the Mode knob. The display will change to the Pro Setup menu and the cursor will flash over
the L in LABELS/AV
5. Press the Mode knob again. The cursor will then flash over the I in INPUT 1.
6. Rotate the Mode knob until the cursor is flashing over the L in LOAD.
7. Press the Mode knob. The display shows LOADING while the program is loaded into memory.