Owner`s manual

your computer or sequencer. If transferring data from one MP-l to another, use one MIDI
cable at a time to avoid MIDI feedback.
SINGLE PROGRAM SAVE:
1. Select the program you wish to save to disk (see "accessing programs" section of this
manual.)
2. Press the STORE button. It will light.
3. Press the BANK button and while holding the BANK button down press the number 5
button. The display will read "Sending Current." When the display returns to the
program number, the save process is complete.
ALL PROGRAM SAVE:
1. Press the STORE button. It will light.
2. Press the BANK button and while holding the BANK button down press the
number 6 button.
3. The display will read "Sending All". When the display returns to a program
number, the save process is complete.
SINGLE/ALL PROGRAM LOAD:
The MP-1 is shipped from the factory with Memory Protect turned ON. Before loading system
exclusive data you must turn the Memory Protect OFF.
1. Press the STORE button. It will light.
2. Press the BANK button and while holding the BANK button down press the number 8
button.
3. The display will read "Protect OFF." When the display returns to a program number,
the Memory Protect is off.
4. To turn the Memory Protect ON, use the same procedure. The display will read
"Protect ON."
Note: Up-loading a single program or all programs via MIDI system exclusive will
erase any/all programs which reside in RAM.
The MP-1 will accept a MIDI System Exclusive file upload at any time provided the Memory
Protect is OFF, a two way MIDI patch described earlier in this section is in place, and MIDI
channel assignments are correct (see "Select MIDI Channel" section of this manual.)
A MIDI System Exclusive file saved to disk from the MP-1, will be recognized and up-loaded
once executed by the sending MIDI device. During an up-load the MP-1's display will read
"Loading." Once you have completed a MIDI System Exclusive upload, turn the MP-1 's
Memory Protect ON.
TECHNICAL
FRONT PANEL CONTROL FUNCTIONS
CLIP Monitors signal level at four points of the circuit. To prevent unwanted
clipping set levels so LED's light only during largest transients.
INPUT Accepts instrument level 1/4" phone jack. Overrides rear panel input.
OUTPUT LEVEL Sets volume without affecting tone or amount of distortion.
LED READOUT Displays selected program number, MIDI channel number, and
mapped program number in play mode. Displays selected parameter's
current value in edit mode.
Page 10