Installation manual

Page 94
The Cinema Rhapsody has a Factory Default recall options which will reset all Cinema Rhapsody
Mach II features to configurations programmed at the factory. Please note, that resetting your unit
to the Factory Default settings will void any changes that you may have made during the Cin-
ema Rhapsody Mach II’s setup.
To recall the Factory Default settings:
1 Turn the Mode knob clockwise until the display’s second line reads SETUP MENU and press
the Mode knob.
2 Turn the Mode knob clockwise until the display’s second line reads PRO SETUP and press the
Mode knob.
3 Turn the Mode knob clockwise until the display’s second line reads FACTORY DFLT and press
the Mode knob.
4 The display’s second line will now read PUSH TO SET. If you are certain that you wish to
proceed with the resetting of the Factory Defaults, press the Mode knob now. The display’s
second line will now read SYSTEM RESET. After a moment, the unit will cycle its power off
and then back on.
At this time you have reset the Cinema Rhapsody Mach II to the factory settings.
Appendix C - Resetting Factory Defaults