Installation manual

Page 40
Turn On Input
When controlling the Cinema Rhapsody Mach II from a remote control or control system, the action of
first selecting an input, causes the Cinema Rhapsody to turn on and switch to that input.
However, when turning the Cinema Rhapsody on from its front panel, by pressing the Volume knob,
the Cinema Rhapsody's Out of the Box default setting will cause it to turn on to the last input that was
used. If you would prefer to have the Cinema Rhapsody turn on to a specific input, every time the front
panel Volume knob is pressed (assuming the unit was off), then follow the steps below. Please note,
that altering the Turn On input from Last Used to a specific device does not affect your ability to turn
the Cinema Rhapsody on to a selected input via its remote control or from a control system.
1 Turn the Mode knob clockwise until the display’s second line reads SETUP MENU and press
the Mode knob.
2 Turn the Mode knob clockwise until the display’s second line reads TURNON INPUT and
press the Mode knob.
3 Turn the Mode knob to select the desired turn-on component and then press the mode knob.
To exit the Setup Menu completely, turn the Volume knob.
Illumination
The Cinema Rhapsody Mach II permits you to adjust the brightness of the front panel not including the
LCD preview monitor. This includes the labeling around the five control knobs, the input/output/mode
lamps, and the two line alphanumeric display. The Cinema Rhapsody Mach II’s Out of the Box setup
has this feature set to 100%. You can opt to set it to a specified value lower than 100% or to AUTO. In
Auto, the Cinema Rhapsody's front panel electric eye will lower the intensity of these displays depend-
ing on room light. The darker the room becomes, the lower the levels go. To alter this setting to either
AUTO or to an alternate percentage value:
1 Turn the Mode knob clockwise until the display’s second line reads SETUP MENU and press
the Mode knob.
2 Turn the Mode knob clockwise until the display’s second line reads ILLUMINATION and press
the Mode knob.
3 Turn the Mode knob clockwise to select AUTO or turn it counterclockwise to select a specific
percentage value. Then press the mode knob. To exit the Setup Menu completely, turn the
Volume knob.