Installation manual
Page 34
Maximum & Turn-On Volume Settings
The Cinema Rhapsody Mach 4 features a com-
prehensive volume control stage that in addition
to letting you access a volume point numerically,
also lets you set a maximum volume level, four
volume presets, and select one of the four volume
presets as your turn-on volume level.
On the PC Program tab labeled VOL SETUP, the
slider permits you to jump to a specic volume
point.
Volume Numeric Direct - This feature is available
on the ADA PC program and lets you jump to a
specic volume point. In the PC program, a virtual
slider accomplishes this. Essentially, when you
release the slider the volume command is sent.
To view this code in HEX, you simply check the
View Commands box and if you wish to copy the
HEX command into a program, merely double-
click on the command itself.
Storing Volume Presets - This tab also enables
you to store the current volume as one of the four
Volume Presets. When on a volume you wish to
store, press the corresponding VOLUME STORE
# button. These four presets can be recalled at
turn on or when an input is selected.
Turn On Volume Preset - You can select one of
the four volume presets as your Turn On Preset
or have the system turn on the last volume setting
by selecting the Last Used option.
From the front panel of the Cinema Rhapsody
Mach 4 while in the Setup Mode navigate to the
VOL SET using the Mode knob and press the
knob. To select a navigate between features,
turn the Mode knob. To alter the setting, turn the
Input knob.
To store a volume preset, rst make certain that
you are at the volume level you wish to store
by turning the Volume knob. Then navigate to
STORE and turn the Input knob to select the
desired volume preset number. Then press the
Input knob to store that preset. The same steps
can be used to Recall a volume preset.
To set the Maximum Volume Level, select that
feature and then turn the Input knob to adjust.