Installation manual
Page 20
DC Triggers & Loading Custom Input Congurations
As a reminder to how the Cinema Rhapsody Mach
4 operates, when you adjust most every feature
on the unit, the changes occur in real time (im-
mediately). That is not the case when it comes
to labeling of inputs, assigning AV jacks, altering
input presets, assigning DC trigger operation, or
changing default modes.
For these specic features, you must load them
into the Cinema Rhapsody Mach 4. Even if you
are adjusting them on the front panel control,
these changes are only being held in the front
panel control and have not yet been loaded into
the motherboard. As such, the front panel con-
trol works much like the PC program which also
needs to be “loaded” into the Cinema Rhapsody
Mach 4.
When using the PC program, you have two load-
ing options which read Send Input or Send All.
Since Send All involves going through all 20 Input
Labels, the Send Input is a nice feature if you only
made a change to a few devices. While on that
Input, press the Send Input button and just that in-
put will be loaded to the Cinema Rhapsody Mach
4. Also, you save the conguration for all inputs
by selecting Save File. Inversely, you can load
a previously stored conguration using the Load
File feature. The Retrieve Input feature loads the
settings internal to the Cinema Rhapsody Mach
4 into the PC Program.
From the front of the Cinema Rhapsody Mach
4, while on the LABELS/AV page, turn the Mode
knob so that the cursor is on INPUT. Turn the
Input knob to select the desired input whose trig-
gers you wish to set.
Turn the Mode knob to TRIG. Turning the Input
knob to select between Triggers 1 & 2, 1, 2, or OFF.
Repeat these steps for all inputs.
To load this and other settings, turn the Mode
knob to move the cursor to LOAD. Then press
the Mode knob. The display will load all settings
input by input.
At this time, you can choose to adjust the Final
Input number, return the previous menu page
(PREV) for other settings, or exit the setup com-
pletely (MAIN).