Installation manual

Page 13
Setup - Entering & Navigation
The Cinema Rhapsody Mach 4 can be setup us-
ing either the unit’s front panel display and knobs
or by using the Cinema Rhapsody Mach 4 PC
Program.
ADA strongly suggests using the PC program
when ever possible as it is more intuitive.
When setting up the Cinema Rhapsody Mach 4
from its front panel, the Mode, Input and Volume
knobs are used to move the display’s cursor and
to make changes or selections.
To enter the Setup mode on the front of the Cin-
ema Rhapsody Mach 4, press and hold the Mode
knob. The display will change to the primary Setup
Mode Screen. Here you can recall Tone, Balance
and Volume presets.
Turn the Mode knob to the desired recall feature
and then turn the Input knob until the appropriate
preset number appears. Pressing the Input knob
will Recall that preset.
From the Setup page you can also set the Cinema
Rhapsody Mach 4’s pararmetric tone control,
speaker balance, volume setup, parametric EQ
as well as entering the Pro Setup mode.
To exit the Setup mode from any page, navigate
the cursor to Main and press the Mode knob.