Operation Manual

1 minute, all indicators will go out automatically, except Water fill indicator which is flashing and the temp.
indicator which is lighting.
When the tank is full, please press the ON\OFF key, then the Water fill indicator will stop flashing and you
can continue to function other settings. When all settings are finished, please press the ON\OFF key again and
the Water fill indicator will go out. And then run the appliance.
When the appliance is running, if there is no operation or malfunction for 20s, the backlight of the display
will go out automatically except the operation model, the outlet temp, the lock indicator. If there is no operation
for 1 minute, the appliance will lock automatically, but the lock indicator would be right all time.
 Lock and Unlock
In order to prevent wrong operation, a special lock function has been designed. If there is no operation for 1
minute, the appliance will be locked automatically, and lock indicator will be displayed. When the appliance is
locked, no keys can be operated.
Unlock:
 Clock set
The clock is for a 24-hour system and the initial time is 00:00. To make a better use of this appliance, it is
recommended to set the time for accurate local time. Every time powered off, the clock will be reset to the
initial time 00:00.
EN 15
 Method for time set:
At the locking status of the display, long press the
“CANCEL”
key to remove it. At the screen protection of the display, press
any key to activate the display, and then long press the
“CANCEL” key to remove it. After removal of the locking
mode, the Lock indicator will blank out and all keys could be
Press the
CLOCK
key, the minute of the the minute
digit of the clock on the display starts flashing slowly.
Press the
„UP”
and
„D
OWN”
key, you can adjust the
minute.