Operation Manual

Minimum space required for operation (in case of operation without air duct 20 m
3
Operation temperature range -7 - +43
o
C
Max. water temperature 60
o
C
COP 15/10-45
o
C ≥3,5
Noise level 48 dB(A)
Type of outlet air Air support flowing vertically upward
Electric heating
Heatable volume 100 l
Voltage/frequency L/N/PE 230V~ / 50Hz
Fuse 5A/250V~(T)
Rated heating performance 1800W
Largest electric power consumption 16 A
Heating time 3,5 h
Max. water temperature 60
o
C
Min. Water temperature 10
o
C
Others
Heat insulation/thickness Freon free PUR insulation / 50 mm
Tank Enamelled steel sheet
Pipe coal Enamelled steel pipe
Corrosion protection Enamel + active anode
Active anode maintenance Anode consumption display
Built-in controller Electric heating and temperature controlling device
EN 11
Electric wiring Fixed
Protection degree IPX4
Touch protection to be applied Touch protection class I.
It can be connected to electric system supplied with protective earthing as defined in Hungarian Standard MSZ 2364.
Regulations on the product: (Hungarian Standards) MSZ EN 60335-1
MSZ EN 60335-2-21
MSZ EN 14511-3
Storage and transportation requirements (Hungarian Standards) MSZ IEC 721-3-1 IE12
MSZ IEC 721-3-2 IE22
Quality certification CE indication
Quality Ist class
Table 2.10.-1.
HAJDU Hajdúsági Industrial Closed Company Limited by Shares (HAJDU Hajdúsági Iparművek Zrt) as
manufacturing company hereby certifies that the appliance comply with the technical features described in the
quality certification label.
USAGE AND MAINTENANCE INSTRUCTIONS FOR THE USER
Thank you very much for purchasing our product.
We hope that the appliance fulfils all expectations and provides the best possible service for You
continuously, besides maximum energy saving.
Before using your appliance, please, read this manual carefully and keep it for future reference.
3. USEFUL RECOMMENDATIONS
3.1. First installation
WARNING !
Putting into operation and first start up of the appliance can only be performed by a technician
according to all related effective regulations or legal requirements or any requirements defined by local
authorities and public health organizations.
If the water heater to be installed does not simply replace an existing appliance but it represents
part of renovation of an existing hydraulic system or a new hydraulic system, the company installing the
water heater shall be obliged to issue a compliance statement for the
buyer, certifying compliance with all effective regulations and specifications after finishing
installation of the appliance. In both cases, the company performing installation has to execute safety and
operation checks on the entire system.