IMPORTANT SAFETY INSTRUCTIONS ) CAUTION A RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS:RISQUE DE CHOC ELECTRIC, NE PAS SOUVENIR THE LIGHTENING FLASH WITH THE NARROWED SYMBOL,WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENT OF INSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF A SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS 10) Protect the power cord from being walked or on pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. 12) Use only with the cart, stand, tripod, brake or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
MIXER SECTION Oneness BATTERY POWERED ? out 415 GAIN VOL Hick MID oo LOW EFF AUX VOL 0 a NOL HIGH MID 10 0 10 EFF 4 VoL. 1-MIC IN: electronically balanced microphone input with input impedance of 1k, input suitable for all types of microphones. 2-LINE IN: balanced line input (both on CH1 and CH2) with an impedance of 470k for connecting instruments with high output signal, you can use both MIC IN and LINE IN together, because LINE IN doesn't seclude MIC IN.
MIXER SECTION 10-PHANTOM (Led Switch): This switch allows for activation or deactivation of phantom power to condenser microphones: Phantom LED on indicates the witch is engaged and phantom power is on. 11-POWER LED: indicates the product is on. 12-MAINS LED: indicates mains electrical current present. 13-CHARGE LED: indicates the internal battery is charging. 14-LOW BATTERY LED: indicates low battery charge.
DESCRIPTION OF CONTROLS = WARNING CATION FOE CONTINUED ROTC ONION GARNET BAIL OF Sine.
TECHNICAL INFORMATION Frequency Response: 60Hz kHz Max Power Out: 80W System Format: One way Amp Sensitivity TW Tm: 92dB SPL Max: 108dB Woofer size: 6" Tweeter: Compression Tweeter Box: 2 way bass reflex Construction: plywood Weight: 15kg Dimensions: height 36,5cm bandwidth depth 29cm PRODUCT DESCRIPTION One for street can be in the following states: State 1: powered by internal battery: in this operating mode the system is autonomous.
PRODUCT DESCRIPTION Level 2: continuing to use the system will continue to drain the battery, leading to Level 2. Reaching Level 2 indicates the passage of the battery from a state of "nearly dead" to that of, "completely dead”. At this Level the system will shut down to avoid totally draining the battery, which would significantly compromise the performance of the battery itself. Upon reaching Level 2 the low battery LED will remain on while power LED will switch off.
PRODUCT DESCRIPTION State 4: Fault: this operative state indicates that the internal battery has been allowed to discharge below the minimum consented level. This state is entered only from State 3 because without mains current the system will have entered its state of self-protection, indicating a discharged internal battery ( low battery LED constantly on, no flashing).
BATTERY OPERATION AND CARE Recharging: can take from a few hours (for a partially discharged battery) to around 10-12 hours (for a totally drained battery). When the product battery is completely discharged, recharge as soon as possible (see point 2). Storage and self-discharge: if the product is stored or not used for a long period of time, the battery must be fully recharged to maintain its charge capacity.
