Troubleshooting guide

DEMONSTRATION
MILLPWR
®
Operation Manual
4-11
• Enter a radius of 0.25 and press the
USE key.
Notice how the last two lines are now "blended" together with a radius.
The
BLEND step could just as easily have been inserted immediately after line 006.
In doing so, the BLEND step would show up in the listing, but it would not be
displayed graphically until the step that follows is added.
• Press the down arrow key once to reach the end
of the program. Now more steps can be entered.
• Press the
LINE key.
TO: X2 = -3.0 ABS
Y2 = 1.5 ABS
• Press the
USE key.