Troubleshooting guide

PROGRAMMING
MILLPWR
®
Operation Manual
3-32
Starting and Stopping a G-code Program
Always start the program from a place in the program where the feed rate, X-, Y-, and Z-
axis position are known, such as a tool step. Alternate starting points can be programmed
by placing the proper code in the desired locations.
Pressing the
GO button will cause MILLPWR to begin executing the current G-code program.
Always insure the program step highlighted is an appropriate starting point.
When a program is running, pressing the
STOP button or the remote pendant will cause the
program and all axis motion to pause. Pressing the remote pendant switch again or the GO
button will cause the program to resume. Pressing the STOP button a second time will halt
the program execution.