Troubleshooting guide

PROGRAMMING

MILLPWR

Operation Manual

3-27

If the program is saved in a different directory:

• Press the

CANCEL softkey.

• Press

PROGRAM FUNCTIONS softkey.

• Press the

DIRECTORY softkey.

• Now press the SELECT DIRECTORY softkey.

• Using the arrow keys, highlight the directory that contains the program you want to

load.

• Press the

SELECT DIRECTORY softkey again. The "DIRECTORY" screen will disap-

pear. Now that you've selected the appropriate directory, you can load your program.

• Press the

LOAD softkey. The directory you chose should appear.

• Highlight the program you want to load, then press the

LOAD softkey. The program

you selected should now appear on your screen.

From a 3

" floppy disk:

• Save, then clear, any open programs.

• From the PGM screen, press the

PROGRAM FUNCTIONS softkey.

• Insert the 3

" floppy disk containing the file you want to load into the floppy disk

drive. Located in the lower right-hand corner of the operator console.

• Press the

DIRECTORY softkey and then press the SELECT DIRECTORY softkey.

• Press the

USE FLOPPY softkey. The “A:” directory and any sub-directories

should appear.

• Select the directory that contains your program and then press the

USE softkey.

• Press the LOAD softkey.

• Press the format key until MPT is displayed.

• Using the arrow keys, highlight the program you want to load. Press the

LOAD soft-

key. The program you selected should now appear on your screen.