Troubleshooting guide

PROGRAMMING

MILLPWR

Operation Manual

3-26

Loading a MILLPWR (MPT) Program

The

LOAD softkey allows you to open programs that have already been

saved. The steps below tell you how to load a program from MILLPWR's

internal memory, a 3

/2" floppy disk, or your PC.

From

MILLPWR's internal memory:

• Save, then clear any open programs.

• From the PGM screen, press the PROGRAM FUNCTIONS softkey,

then press the LOAD softkey. The last directory that was selected

and any programs it contains will appear.

If the program is saved in the

MILLPWR directory:

• "MILLPWR" should appear at the top. If it doesn't, check that the

USE FLOPPY and REMOTE STORAGE softkeys are not selected.

• Press the format button until MPT is displayed.

• Using the arrow keys, highlight the program you want to load, then

press the LOAD softkey. The program you've selected should appear

on your screen.

If you’re loading

a program that

was created on a

two-axes sys-

tem, you will

have to add Z-

axis information

before you run

the program.

If you don’t want

to add the Z-axis

information,

consider dis-

abling the Z-axis

control and run-

ning in 2 axis

mode.

Refer to “Setup”

for further

instructions.