Troubleshooting guide

PROGRAMMING
MILLPWR
®
Operation Manual
3-23
Deleting a Directory
MILLPWR will not delete directories that contain programs. You must delete each program and
subdirectory stored within the directory first (refer to Deleting a Program).
To delete a directory:
• From the PGM screen, press the PROGRAM FUNCTIONS and DIRECTORY softkeys, then
press the DELETE DIRECTORY softkey.
• Identify where the directory you want to delete is located.
On
MILLPWR's internal memory:
"MILLPWR" and any subdirectories you have created should appear under the
"DIRECTORY" heading.
On a 3
1
/2
" floppy disk:
Insert the 3
1
/2
" floppy disk containing the directory into the disk drive (located in the
lower right-hand corner on the front of the operator console) and press the
USE FLOPPY
softkey. "A:" and any subdirectories you have created will appear under the
"DIRECTORY" heading.
On your PC:
Press the
REMOTE STORAGE softkey. "REMTSTOR" and any
subdirectories you have created will appear under the
"DIRECTORY" heading.
• Using the arrow keys, highlight the directory you want to delete.
• Press the
ENTER key. Press the YES softkey to erase the directory
or the NO softkey to cancel.
The REMOTE
STORAGE soft-
key will only
appear if MILL-
PWR has been
set up for remote
storage.