Troubleshooting guide

SETUP

MILLPWR

Operation Manual

7-17

Installation Setup

After you’ve selected

“Installation Setup” from the

“Job Setup” list, you will be

asked for a passcode. The

passcode is located on the

page before the table of con-

tents. You can remove it and

store it in a separate location

to prevent accidental or

unauthorized adjustments to

your system. Once you’ve

entered the passcode, the

“Installation Setup” screen

will appear.

Protection

Protection enables you to prevent unauthorized access to your

part programs and tool library. With “Part Program” and “Tool

Library” set to “Yes,” your part programs and tool library cannot

be altered—without first changing your “Part Program” and/or

“Tool Library”setting’s to “No.”

o change your protection settings:

• From Installation Setup, highlight PROTECTION then

press

ENTER.

• Use the

NO and YES softkeys to disable or enable protection for both the “Part

Program” and “Tool Library.”

• Press the

USE key.

• Continue with Setup or press the

USE NEW SETTINGS softkey.