Troubleshooting guide

SETUP
MILLPWR
®
Operation Manual
7-16
Feed Rate Settings
Here you can change the default settings for various speeds and feeds:
STEP OVERRIDE % determines the percentage of change that occurs
when you press the
FEED+ and FEED- keys.
MAX % establishes the maximum feed rate percentage that the FEED+
key will allow.
MIN % establishes the lowest feed rate percentage that the FEED- key
will allow.
DRY RUN SPEED is the speed that the table will move during a dry run.
DEFAULT FEED RATE enables you to define the table’s and Z-axis’
default feed rate for all milling functions—this way, if you forget to
enter a feed rate,
MILLPWR will automatically apply your default feed
rate to the milling function. We suggest that you set your default feed rate to the rate that you
use most often.
UNIT/MIN lets you define your feed rate in either inches per minute or millimeters per
minute.
FULL CUT FEED RATE % is the percentage of the programmed feed rate used when the tool
is making a full cut (e.g., the beginning cut in a pocket).