Troubleshooting guide

SETUP
MILLPWR
®
Operation Manual
7-15
To start the job clock:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the
START softkey, and the job clock will begin.
T
o stop the job clock:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the
STOP softkey, and the job clock will stop. The job clock’s current time will
be added to the value in the“Elapsed Time” field.
• To restart the job clock, press the
START softkey.
T
o reset the job clock and the “Elapsed T
ime” field:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the
RESET softkey, and the job clock and “Elapsed Time” field will be cleared.
Job Clock
Note: The maximum
amount of time that the
job clock will record is
99 hours, 59 minutes
and 59 seconds. The
value will then roll
over to zero and con-
tinue counting.