Troubleshooting guide

SETUP
MILLPWR
®
• Remove any tool from the spindle.
• From the DRO screen, press the
TOOL key.
• Enter zero for the diameter and zero for the tool length.
• Press
GO.
• An Operator intervention message will appear asking you to “use” the entered tool.
• Press GO again.
• MILLPWR is now set with a zero tool length offset.
• Press the
DATUM softkey.
• Touch the spindle nose to a solid surface such as the top of a vice or your workpiece.
• Press the
Z=0 softkey, then the USE key.
Datum zero for the Z-axis is now set to the surface that the spindle nose touched. Use this same loca-
tion to “teach” each tool length in the tool library.
• Press the
SETUP key and highlight “tool library.”
• Press ENTER.
• Highlight the tool number in the tool library list, for the tool you are setting up and press
ENTER.
• Use the numeric keypad to enter the tool’s diameter.
• Highlight the “unit” field. If the diameter you entered is metric, press the
MM softkey.
• Highlight the length field.
• Place this tool into the spindle and touch its tip to the same surface you used to set the
Z-axis datum Zero.
• Press the
TEACH TOOL LENGTH softkey. The length offset for this tool will appear in the
length field.
• Highlight the “Type” field.
• Press the
TOOL TYPES softkey.
• Highlight the type of your tool from the list of available tool types and press
ENTER.
• Press USE.
• Repeat this procedure for all additional tools then, press
USE NEW SETTINGS to com-
plete the setup.
After the tool information is established in the library, you can edit the values as needed to complete
the setup.
Operation Manual
7-6