Troubleshooting guide

CALCULATOR
MILLPWR
®
Operation Manual
6-16
• Press the
CANCEL key to return to the program. Check that your cursor is just below the
line previously programmed (item 001).
• Press the
LINE key to begin a new “Mill Line” form. The “From” point is automatically
set at point B. The “X2” field should be highlighted. This is point C, one of the points
found in GeoCalc.
• Press the
CALC key, then the GEOMETRY softkey.
• Highlight the GeoPoint representing point
C (step 004). Press the
RETURN FEATURE soft-
key. The program screen will return and point C’s
coordinates will appear in the “To” field.
• Press the
USE key to accept the line into the part
program.
• Press the
CALC key and then the GEOMETRY softkey.
The features in
the calculator
will not be
lost until the
MILLPWR is
turned off or
until you clear
the calculator.
Returning Features
Now bring the GeoCalc results back into the program. When you press the
RETURN FEA-
TURE
softkey, GeoCalc will transfer the feature you’ve identified into your part program.